Mark Ingalls wrote: > > Hi Volks, > > I am replacing the rear brake shoes on my 85 GL and I plan on taking the > rear wheel bearing housing off to inspect and grease the rear bearings. I > will follow Bentley's procedure. > > I've done bearings on Type 1's before. Any pitfalls or tips for doing this > on a Vanagon? > > Mark Ingalls I'd like to add, bearings in general- . Replace ALL grease in there if you are repacking, don't mix old and new. Chemical changes can break down the protection and you will ruin the bearing, besides you get to remove accumulated grit and dirt too. . Try synthetic, Redline makes some great red stuff. TBerk |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.