on 11/15/2000 10:00 PM, Bradley Flubacher at flubach@HOME.COM wrote: > must you drain the coolant to replace the temp 2 sensor? Or just bleed it > afterward? Or neither? > > Thanks, > Bradley Flubacher > State College, PA > (Not speaking for the 2.1, but they prolly aren't much harder.) On 1.9L's If you do it fast enough-neither. Remove the plug, be ready with the new one really close by as the old one starts to come out. Install the new one. You should only lose about a tablespoon of coolant.
Dave C Williamsburg, VA ญญญญญญญญญญญญญญญญญญญญญญญ "Luke, try not. Do or not do. There is no try." - Yoda |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.