In a message dated 11/15/00 9:55:22 PM, flubach@HOME.COM writes: << must you drain the coolant to replace the temp 2 sensor? Or just bleed it afterward? Or neither? >> Bradley, The ones that I have changed have been the threaded type as used on the 1.9L and the Syncro. With these, I had everything ready to go before I removed the sensors. By plugging the orifice with my finger between removing the old and threading in the new, almost no coolant was lost. Of course, you want to do this on a stone cold engine. Ri |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.