Bill, Syncros have the same adjustment clamp between the front and rear shift rods as 2WD models. Yes, it is possible to move it less than a spline or I would not have suggested it. The male end has splines but the female socket is smooth so this allows infinite adjustment when the clamp is loosened. Mark Bill Davidson wrote: > > Hi Mark., > assuming you information below applies to the Syncro... > > is 'the clamp' you are talking about below the same as the one shown in the > upper right part of the diagram on page 34.20 of the bentley... the nut that > secures the clamp is labeled "25Nm (18 ft lb) ?????? > > also... is it possible to move it less than one spline??? though splined > connections only move one spline at a time? > > Thanks > Bill > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.