Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 2000, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 13 Dec 2000 00:23:05 -0800
Reply-To:     Todd Last <Rubatoguy@MINDSPRING.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Todd Last <Rubatoguy@MINDSPRING.COM>
Subject:      Re: Leaky Oil cooler 89 GL
Comments: To: "Stanley, Kerry" <kstanley@CAS.ORG>
Content-Type: text/plain; charset=us-ascii

My '88 had a leak in the same place, which resulted in a nice spotty coating of oil on the back hatch. However I noticed that the problem was simply that the nut holding the oil-cooler on had worked loose slightly allowing oil to seep past the O-ring. Something to put on the list to check when you change the oil and filter.

Todd '88 Westy

"Stanley, Kerry" wrote:

> Hi all, > > If you have an older vanagon do replace this o-ring. As mentioned there was a modification made sometime after the '86 model year to a better o-ring. I also had some oil leak out in real cold weather but then it would stop leaking. BUT the o-ring eventually just cracked and no way it was going to hold oil. And besides always happening late at night, it happens at zero degrees - not much fun. > > Also those two hoses to the oil cooler should be replaced. Trying to get the oil cooler off will pretty much ruin any dried old hoses. I had one of these hoses burst a week after having the new o-ring replaced by a friendly, but not vw aware mechanic. > > Kerry > '86 syncro, 176K > kstanley@cas.org > > -----Original Message----- > From: Jeff and Tamara Nelson [mailto:ramjeff@earthlink.net] > Sent: Tuesday, December 12, 2000 7:10 PM > To: vanagon@gerry.vanagon.com > Subject: Re: Leaky Oil cooler 89 GL > > I neglected to change out the 20W50 in my 86 before a trip to the > midwest this fall. When we got some cold weather, I had a gusher from > the top of the cooler for a few seconds every start. Changing the oil > to 10W40 fixed it. I was thinking the high oil pressure blew past the > seal on start-up. Is this right and if so, should I bother to replace > the seal? > > JN > > KENWILFY@AOL.COM wrote: > > > > There is an o-ring on top of the cooler than is known to fail in cold > > weather.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.