I had a look and the shaft diameter of the bolt that runs horizontally through the rubber mounts is approx 10mm. alistair
on 1/1/2001 3:42 PM, Carolyn Kitzmann at kitzmann@EXIS.NET wrote:
> > Second question. In the mess of the conversion I can't locate the bolts > that went through the engine mounts. A 10 mm bolt slides in easily and has > some wiggle room, but a 12mm doesn't go in at all and looks to be only > slightly larger then the hole. If someone could look and see if the bolts > are 10mm or something else would be appreciated. > > Thanks, > Dave > > 82 Vanagon Diesel, soon to be Golf powered > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.