What direction should the clip holding in this sensor face? Since the idea of facing is ambiguous, let's say that given the U shape of the clip, where should the bottom part of the U be? In the manual, it shows the bottom on the engine side. On my '87 the bottom of the U faces the firewall (180 degrees off) making it hard to grasp and pull off. Another list member said he pulled the clip off by pulling up. That is, the bottom of the U was at the top of the sensor. I'm asking if any of this matter at all. The problem as I see it for now is that it's a bit difficult to pull the clip off if it's facing forward. There's not much room there. Is one direction (perhaps the one shown in the manual) correct. Thanks for the help, David |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.