Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2001, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 12 Jan 2001 14:51:06 -0500
Reply-To:     David Beierl <dbeierl@ATTGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Beierl <dbeierl@ATTGLOBAL.NET>
Subject:      Re: Coolant Temp/Coolant Level LED and  Flashing Oil LED -
              Instrument Cluster Upgrade... Advice required on continuous
              flashing Coolant LED.
Comments: To: Chris Mundy <cwmundy@OPTUSNET.COM.AU>
In-Reply-To:  <000801c07c8b$308e3ba0$64646464@oemcomputer>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 06:31 AM 1/12/2001, Chris Mundy wrote: >1. The flashing LED for the Coolant Temp/Coolant Level LED doesn't want to >go out, it keeps on flashing. Yes I have checked it on the original dash and >it works according to the normal routine, and the coolant levels are also >ok. > >Any Suggestions????

If as I suspect the gauges themselves are the same, swap them. Failing that, take the existing one apart (no fun) and get somebody electronic to fix it -- it's a lamp-test function that's supposed to operate for a few seconds after power is applied. I suspect that replacing the electrolytic cap will do it, but that's just a semi-educated guess -- and you still need to take the blighter ever-so-delicately apart.

>2. My current Oil LED Flashes while awaiting for Oil pressure and the one on >the replacement cluster does not flash, it has a constant glow until the >engine has oil pressure. Would this be because of the age of the LED used on >previous models? > > >Suggestion????

If it's an '85 panel, it will have a cavity in the speedometer for the dynamic oil-pressure warning circuit board -- but no board. I believe the circuit foil has contacts going over there, but has been jumpered at the factory with one or two little staples to pass the sender signal straight through to the LED. If that's the case you can take the board from your other speedo and use it after removing (carefully!!!) the jumper(s).

david

David Beierl - Providence, RI http://pws.prserv.net/synergy/Vanagon/ '84 Westy "Dutiful Passage" '85 GL "Poor Relation"


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.