Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2001, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 14 Jan 2001 05:43:52 -0500
Reply-To:     Lawrence Johnson <larry_avery.johnson@SYMPATICO.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Lawrence Johnson <larry_avery.johnson@SYMPATICO.CA>
Subject:      Re: allen wrench for gear oil change
Content-Type: text/plain; charset=us-ascii

Paul Gilland wrote:

> I went out and bought a 17 mm allen wrench, and although it is the > proper diameter, the wrench is too physically large to fit t he drain > plug because the (stock) 'exhaust pipes are too close.

Paul, I took my dremel tool and cut a 3/4 inch long piece of the end of the allen wrench. This stub piece worked perfectly with a 17 mm box end wrench. -Larry


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.