Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2001, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 14 Jan 2001 13:37:23 EST
Reply-To:     JKrevnov@AOL.COM
Sender:       Vanagon Mailing List <>
From:         Rico Sapolich <JKrevnov@AOL.COM>
Subject:      Re: allen wrench for gear oil change
Comments: To:
Content-Type: text/plain; charset="US-ASCII"

In a message dated 1/14/01 11:51:42 AM, azsun99@EARTHLINK.NET writes:

<< Once again, the best tool is available and cheap >>


Because it is such a relative matter, you cannot use the superlative to describe the tool about which you speak. Is it best to wait a week or more to receive a Chinese tool of dubious quality or is it best to hack off an inch of fine American steel and get on with the job? Moreover, the 17 mm hex driver cannot be used to remove a Syncro's transmission drain plug unless the skidrails cum bashplate are first dropped. Like I said, it is all relative.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.