Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2001, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 17 Jan 2001 20:55:11 -0800
Reply-To:     Brent Christensen <brent@VANAGON.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Brent Christensen <brent@VANAGON.COM>
Subject:      Re: [Syncro] Air Flow Metre cheap fix?
Comments: To: LA & Glen <lagcook@telusplanet.net>
Comments: cc: Syncro@egroups.com
Content-Type: text/plain; charset="iso-8859-1"

Here's something from David Beierl dbeierl@IBM.NET on the vanagon List, who I consider to be the sharpest guy on vanagon Electonics (aside from Darrel Bohler and the ECU's):

Many people have had success by installing a 22 uF 35v tantalum capacitor across the AFM active leads, cost about $2.50 plus your time and solder.

In the case of a worn AFM, cleaning the carbon track is helpful, as is slightly relocating the board so that the wiper tracks in a different area. You may have to open out the mounting holes a little to move the board, but it only has to move a little -- 1mm maybe? The wiper has two contacts, so you wnat the new tracks to straddle one of the old ones.

A worn AFM can definitely cause poor idle and no doubt highway bucking as well. If replacing it cures the problem, then it was *not* the problem that VW designed the special harness for -- although that harness or the capacitor may well help.

--A side note from the archives from kenneth d lewis <kdlewis@JUNO.COM>: Mount the capacitor inside i.e. under the cover. One lead goes to the wire corresponding to the "wiper arm". The other lead goes to the wire that is at ground potential.

Brent Christensen '89 GL Syncro Westy Santa Barbara, CA

----- Original Message ----- From: LA & Glen To: Vanagon Cc: Syncro@egroups.com Sent: Wednesday, January 17, 2001 6:35 PM Subject: [Syncro] Air Flow Metre cheap fix?

Hi Volks,

I am looking for the info on the cheap fix for the "Vanagon Syndrome" . There is a part available from the dealer but as I understand a resistor or some thing can be put across some of the wires for the air flow meter. Does any one have any info on this or can they direct me to a web site with the info?

Thanks Glen

If you would like to modify your subscription settings (including unsubscribing), visit: http://www.egroups.com/subscribe/Syncro


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.