Replaced the ign switch, swapped the load control relay, cleaned all the grounds, and fixed the horn ground. Voltage fluxuation stays normal with the heater switch on high but now the motor cuts-out (on high only). Do you think that running a separate circuit with a relay on the "high" switch position will cure this or is it maybe the resistor or too much friction in the motor? I don't have any blank fuses on the panel to add to. Where should I tap into for a switched source to addanother small fuse panel for this heater relay and maybe a horn relay? Thanks again, Ken Hunter 82 Westy 1.9D 84 Jetta 1.5D |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.