|
Well heck! Just redid all my fuel lines on my 84 westy and replaced the injector seals at the same time and was very proud that I didn't break anything while doing it. So this morning after doing one more check on all the fittings I hooked the battery up, turned the key and ..... no start! I get power to the fuel pump etc but the started doesn't do anything at all. I know that the battery is in full charge and that the starter is good. Have I knocked one of a zillion connections off or broken a wire or both? Since all the fuel lines are empty.... is there anything in the system that senses that and won't allow the ignition to kick over? Any ideas would be greatly appreciated. TIA Bob 84 westy Das Bus |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.