Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2001, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 28 Jan 2001 17:39:54 -0800
Reply-To:     Zoltan <zol@FOXINTERNET.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Zoltan <zol@FOXINTERNET.NET>
Subject:      Wire harness hardening
Content-Type: multipart/alternative;

As the headline says, I am concerned about the cracking of the wires and the subsequent short it can make or touching each other. Is there a way to make the plastic fresh again? I remember there was a thread about the trims to renew by warming them up to 300F. Is this possible in this case too? Or is there some kind of liquid to soak it in or a spray that would help? Zoltan


[text/html]


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.