Date: Wed, 7 Feb 2001 19:41:55 -0800
Reply-To: David Marshall <vanagon@VOLKSWAGEN.ORG>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: David Marshall <vanagon@VOLKSWAGEN.ORG>
Subject: Re: vanagon golf engine conversion problem
In-Reply-To: <3.0.6.32.20010207195805.00827a70@mailhub.exis.net>
Content-Type: text/plain; charset="US-ASCII"
You didn't say what FI system you are using. Are you using CIS, CIS-E,
Digifant II or Motronic?
It really sounds like you are using the CIS system with a warm up regulator
that is mounted next to the distributor on the block. If it is, it is the
warm up regulator that is not functioning correctly. You "cold" pressure is
too high. The only real way to test this is to use a fuel pressure gauge (I
have them) or swap in a different fuel pressure regulator that is know to
work.
If it isn't CIS let me know and I can point you in the right direction!
David Marshall
Fast Forward Autobahn Sport Tuning
4356 Quesnel Hixon Road
Quesnel BC Canada V2J 6Z3
mailto:info@fastforward.ca http://www.fastforward.ca
Phone: (250) 992 7775 FAX: (250) 992 1160
. Vanagon Accessories and Engine Conversions
. Transporter, Unimog and Iltis Sales
. European Lighting for most Audi and Volkswagen models
-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf
Of Kitzmann
Sent: February 7, 2001 4:58 PM
To: vanagon@GERRY.VANAGON.COM
Subject: vanagon golf engine conversion problem
I first wanted to apologize to everyone that wanted pictures of my
conversion, but I still haven't been able to abscond with my friends
digital camera yet.
Now for the problem. As you may remember the last time I wrote I had only
let the van run for a few seconds because I didn't have an exhaust on yet.
Well I got an exhaust system built (I think it is a neat system, more on
that latter)and got the thing running for real. The problem is it starts
up fine, runs for 15 seconds or so and then starts stumbling and will stall
if you don't keep the throttle in a little bit. After it warms up for a
while it will continue to run fine without need to blip the throttle at
all. But, heres the real problem. If the van is allowed to stall it
becomes harder to start each time you try to start it. If the engine is
allowed to warm up for say a minute and you shut it down and then try to
start it again it just cranks and cranks and never catches. But if you let
it cool down for 30-40 minutes it seems to fire right back-up.
So far I have tested the O2 sensor (bad so I got a new one), all the
grounds, vacuum lines, any connections to the intake manifold and airflow
sensor, cold start system, coil, rotor, cap, various electrical connections.
Does anybody have any idea what maybe causing this?
Dave K.