In a message dated 2/11/01 2:41:21 PM Eastern Standard Time, wilpho@MCN.NET writes: << Anybody got any good ideas on this?? >> No but here are some bad ones.. pull the starter of and wirebrush the face where it seats on the tranny..then clean the tranny area too...put it back and make SURE that the top bolt is the first one you tighten.... Next...check ...heck..CHANGE the ground strap between the tranny and the body.... after that? add a "ford solenoid" to the system like on the old buses.. you should be goo to go..unless it''s just a bum starter steve "Hey! nice Jeep, Mister! " "Look kid, it's NOTAJEEP! " |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.