Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2001, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 9 Feb 2001 11:26:06 -0500
Reply-To:     Jay L Snyder <Jay.L.Snyder@USA.DUPONT.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jay L Snyder <Jay.L.Snyder@USA.DUPONT.COM>
Subject:      Lo Oil Pressure-Con Rods Mainly the Problem?
Content-type: text/plain; charset=us-ascii

I have a 1.9l with low oil pressure. Is it mostly due to the con rod bearings, or is it also main bearing wear? Would rebuilding the rods alone be worth doing, especially since main bearings are hard to find? Can this be done without splitting the case, or must you still do that? I would hate to tear it down that far and not do the main bearings. If you only do the rod bearings, how can you tell if the crank is still OK? Do the cranks not wear very much? Just wondering and biding my time.

Jay '85 Westy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.