>I have a sender unit I need to check before I install. How to check? The fuel gauge sender is a variable resistor. As the float floats up and down in the gas it moves over contacts that send varying amounts of resisatance to the fuel gauge. To test connect a voltmeter to the 2 contacts on the outside of the sender and measure the resistance with the buoy at different positions. I'm not sure of the values but someone has recorded them and they are either in the message archives or ftp section of vanagon.com. If you don't have access to a voltmeter you could even connect the sender (out of the tank) to the gauge, turn on the ignition and move the bouy and arm up and down and see if the gauge responds. Hope this helps, Andrew Fox Looking to buy a gasoline heater. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.