Date: Mon, 19 Feb 2001 16:27:56 -0500
Reply-To: Robert Donalds <bostneng@FCL-US.NET>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Robert Donalds <bostneng@FCL-US.NET>
Subject: flexing cranks and Yielding Bolts one last time
Content-Type: text/plain; charset=us-ascii
fellow listees and learkers
I found a great article about the stretch to yield hardware in this months
automotive rebuilder magazine it is also on line at
http://www.automotiverebuilder.com under feature articles. I hope this will
clear up the confusion about the hardware on the 2.1 rods
the bug crankshafts as everybody knows flexes. when I was building formula
vee engines that would spin up to 6k on the track flexing could be a problem.
After all the 40 hp crank was much better at flexing than was the 1500 or 1600
cross drilled cranks To get around this problem I always had the center main
ground .0015 ths. below the low limit and that gave the crank the needed room to
flex, live and see yet another race
The first symptom of a flexing crank is that the case takes a pounding at
the center main web. The common belief is that the crank flexes when it is at
top dead center There is a second symptom of the bug crank flexing that I have
never heard discussed and that is the crank center main bearing journal ware. I
have inspected and measured lots of cranks in my time and the one place the bug
crank shows it ware first is at the center main oiling holes. It is not uncommon
to see 0015ths. out of round at this spot This is not from lack of lubrication
but a result of the crank flex then the pistons are half way in there travel. I
have never seen any signs of this in any 1.9 or 2.1 crankshaft that I have
measured ever.
It is not uncommon to put a 2.1 case back into service after 150k because
the case measures fine you could not say that with any bug case with even 1/2
that number of miles
sure its been done but the person that did it never measured the case and sure
it didnt bind until it got hot but how would whey know the cranks binding the
only symptom of this is it ran really hot and didnt make allot of power
Bob Donalds
http://www.bostonengine.com
as always
all rights reserved
>
|
Back to: Top of message | Previous page | Main VANAGON page
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives
@ gerry.vanagon.com
The vanagon mailing list archives are copyright (c)
1994-2011, and may not be reproduced without the
express written permission of the list administrators.
Posting messages to this mailing list grants
a license to the mailing list administrators to reproduce
the message in a compilation, either printed or electronic.
All compilations will be not-for-profit, with any excess
proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively
towards the management and operation of the Vanagon mailing
list and vanagon mailing list web site.