Hi all, The Bentley manual 80.16 shows that the restrictor should go in the "inlet" hose that feeds into the water valve on the side of the heater core. However, on page 19.10 it is noted that on the 1983-1985 vans, the metal T-piece (that feeds the rear heater) should be replaced with the uprated white plastic version and the flow restrictor from the inlet fitting of heater valve should be removed (omitted?). This comes from a Bentley manual covering 1980-1991. Earlier Bentley editions did not include notations of upgrades and improvements. Hope this is helpful. The issue of replacing this restrictor has come up many times. Kevin Dawson 87' Wolfie 1/2 camper |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.