Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2001, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 6 Mar 2001 09:10:46 -0800
Reply-To:     Mark Keller <kelphoto@ISLANDNET.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Keller <kelphoto@ISLANDNET.COM>
Subject:      O2 Sensors, and harness connetion failure
Content-Type: text/plain; charset=us-ascii

I posted that O2 sensor provides corrective data, to the ECU. The O2 sensor doesn't control the ECU, engine, or the AFM.

The O2 sensor harness, has been written up in the technical bulletins as a failing on some vehicles. There is a VW kit, to replace the O2 sensor lead from the engine compartment to the ECU connector.

Engine's which run oddly when a known good O2 sensor is installed, should be examined for the wiring harness fault.

You can measure continuity from the harness connect to the engine compartment connector to verify this.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.