Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2001, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 11 Mar 2001 20:13:45 -0600
Reply-To:     Steve Sandlin <carlocks@TXUCOM.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Steve Sandlin <carlocks@TXUCOM.NET>
Subject:      Re: Slider door handle

On the subject of machining a billet handle, yes it can be done. Remember, though, that the handle is the outer part of the lock. There is a lot of intricate stuff going on in the bottom of that lock concerning the return spring, latch actuator, rotational stops, etc. With enough dead presidents, anything is possible, but I wouldn't want to foot the bill on machining a handle from scratch. No need to re-invent the whel, IMHO. Steve Sandlin http://www.steveslockshop.com '84 Wolfsburg Westy '79 Transporter '00 New Beetle


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.