Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (March 2001, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Tue, 20 Mar 2001 15:05:06 -0700
Reply-To:   Keith Adams <keith_adams@TRANSCANADA.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Keith Adams <keith_adams@TRANSCANADA.COM>
Organization:   TransCanada
Subject:   Re: resurface flywheel?
Comments:   To: Stuart MacMillan <macmillan@HOME.COM>
Content-Type:   text/plain; charset=us-ascii

> In reality, the only time a flywheel needs to be resurfaced is if the > disk has worn down to the rivets and the flywheel is scored. Even then > the scoring can't be too deep or it is scrap.

I would beg to differ. As a shop boy in a machine shop, I got the dirty job of re-surfacing flywheels. Even ones which didn't show any signs of warpage or damage still had lots of hard spots in the mating surface due to people driving while slipping the clutch, worn pressure plates, etc. The hard spots tend to "glaze" more and will affect the way the clutch disc slips on the flywheel. You can also hear the hard spots go by in the lathe, as they make little "thunking" noises as they hit the cutting tool. I never took off much of the surface. Just enough to get the hard spots out (like 1/16" or so). I do all my flywheels, because after all, when's the next time you're going to be able to get at it? Besides, whack a half inch off the flywheel and you get better acceleration right? *smirk*

YMMV Keith Adams Calgary, AB, CA 86 Westy "Roxy" / 87 Syncro project "Hugh"


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.