Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2001, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 15 Mar 2001 23:42:37 -0700
Reply-To:     Steve Blackham <steph@USWEST.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Steve Blackham <steph@USWEST.NET>
Subject:      exhaust nuts and bolts
Comments: To: Tom Goff <vanagon@TGOFF2.GSFC.NASA.GOV>
Content-Type: text/plain; charset="us-ascii" ; format="flowed"

Tom

I've used galvanaized nut and bolt combinations on my VW's exhaust for years.. I just go down to Home Depot's fence department (or the like) and buy replacement fasteners. They usually don't have to be metric. For Exhaust port nuts, ask your local VW Flaps for brass alloy replacement nuts.

Tom Goff <vanagon@TGOFF2.GSFC.NASA.GOV> wrote: Subject: exhaust nuts and bolts

I just went through the replacing exhaust pipes blues. I had to use nut spliters, destroyed a sawsall blade, exercised the cutting torch, and only nicked two knuckles. I still only managed to replace the muffler, tail pipe, "J" pipe and the rear main pipe to number 2/4 cylinders. I found two bolts holding the exhause to number 2 cylinder, normal nuts on number 4 cylinder, odd bolts/nuts on the J to muffler (one was a hardened bolt (see sawsall blade above)), and two VW nuts. I define VW nuts as the steel nuts with "helicoil looking" brass colored threads as used in the early aircooled bugs.

I am soliciting advice from the group concerning the replacement of all bolts/nuts (metric 8-1.25 of various lengths) with stainless steel, berillium, or whatever it takes to make this job less painfull in the future. The forward number 1 and 3 cylinder pipe is still original but there isn't enough left of the nuts to consider using a wrench, etc. to try to remove them so I let sleeping dogs lay until I have to replace this pipe too. I suspect that I will have to torch the nuts off, thereby destroying the studs. Is it an OK idea to replace the cylinder studs with stainless bolts?

------------------------------------------------ Tom Goff - 1984 full Westy - original ower, 92K miles - Highland, MD

------------------------------ --

Steve Blackham M.S.M.D.

"Is density a four letter word?" http://www.ourcenterville.org/blackham/page1.htm

Centerville S.F. Bay Area Field Trip Slide Show http://www.centervilleut.net/Govt/CommDev/UrbanVill/01_UV.htm


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.