Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2001, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 20 Mar 2001 07:51:52 EST
Reply-To:     JKrevnov@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Rico Sapolich <JKrevnov@AOL.COM>
Subject:      Re: CV Boot replacement..
Content-Type: text/plain; charset="US-ASCII"

In a message dated 3/19/01 11:39:03 PM, turbovans@JUNO.COM writes:

<< 1. if you have 6 - point allen CV joint scews do not install them back in but instead get the later type 12- point allen screws - they never strip out, and the 6-pointers always do. >>

I diagree. Using a quality driver whether it is a hex socket or a tri-square and making sure it is FULLY inserted into the socket will give the desired result.

Rich


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.