Date: Fri, 6 Apr 2001 22:05:16 -0700
Reply-To: mike miller <mwmiller@CWNET.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: mike miller <mwmiller@CWNET.COM>
Subject: Re: red&white wires, green&black wires, refer madness!
Content-Type: text/plain; charset="iso-8859-1"
OK, darn it. You can explain this but not the Canuck thing? Obviously
you're some sort of spy.
Mike
----- Original Message -----
From: David Beierl <dbeierl@ATTGLOBAL.NET>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Friday, April 06, 2001 6:58 PM
Subject: Re: red&white wires, green&black wires, refer madness!
> At 08:09 PM 4/6/2001, radish150 wrote:
> >Howdy folks, I'm stickin in this here westy kit and I'm down to a few
> >wires with no place to go. A few notes on the wiring
> >from the wrecking yard woulda been real helpfull, but they have my money
> >now and well, you know. So what I have is one pair
> >of wires right under the sink that are screwed into the front cabinet
wall
> >right under the sink, they could just be hooked
> >together (the terminators would allow this), anyone know where these go?
>
>
>
>
> >I also gots me a pair of wires also under the sink, one black one green,
> >completely homeless. So far I have NO connections
> >to the vans wiring system so some of these obviously go to simple 12V and
> >ground.
>
> LED panel connector: pin 1, yellow to faucet switch then yellow to water
> pump. Also jumpered to pin 4.
> pin 2, green to water level sender
> pin 3, black to reefer thermocouple at T1
> pin 4, red to cold end of 8-amp fuse at door pillar, also red to reefer
fan
> at T3a/1, also jumper to pin 1
> pin 5, open
> pin 6, black to reefer ground at T3a/2 and thence to chassis ground.
>
> Brown wires from water pump and level sender connect together and thence
to
> chassis same place as the reefer ground.
>
> Reefer relay (mounts under driver's seat) 2.5 Red from battery to 87 and
> 1.5 Red from 87 to 8 amp fuse (hot side) at door pillar.
> 2.5 Red from pin 30 to 16 amp fuse at door pillar and thence to reefer
T3a/3.
> 0.5 black to alternator D+.
> 0.5 red/black to ignition switch terminal 50
>
>
>
>
> >Other mystery is.... on the side of the fresh water tank there are 3
> >terminals where wires attach, they then go to a little
> >black box on the tank. It's fairly clear even to me that these are for
> >water level sensing, but I see no way for these to
> >connect to the other cabinet with the LED's ??? How does this black box
> >connect to the other cabinet????
>
> Goes to the green wire. The taped-up black wire goes nowhere.
>
>
> >Ok, last one. My fresh water drain presently consists of a threaded hole
> >in the bottom of the tank. What's the factory
> >configuration on this?
>
> Goes through hole in the floor, has screwcap
>
> > Other (ok I lied) thing is my sink drain is the same except for not
even
> > a hole in the floor. Does
> >this large black sink drain just dump out onto the ground or are the two
> >drains tied together somehow? I know the bottom of
> >this black sink drain hose used to connect to something becuase it has
> >clamp marks on it.
>
> Goes to garden-hose fitting in floor.
>
>
> >so much for a "complete" kit.
> >
> >thanks to ya'all
> >
> >mark...
>
> David Beierl - Providence, RI
> http://pws.prserv.net/synergy/Vanagon/
> '84 Westy "Dutiful Passage"
> '85 GL "Poor Relation"
>
|