Ok, the red (of the red/white pair) is for 12V and when connected the battery indicator lights up. The paired white wire is connected to a relay on the back of the refer, but that's all I could ascertain about that wire. Of the green/black pair I found that these are connected to the water level indicator and varying finger pressure using my body as a resistor I guess, results in the full range of water levels. What's wierd tho is the water level indicator only lights when the switch is pointing to the "battery" position (I get both readouts as the same time this way) but nothing lights when it's pointed to "water" position???? Hope this helps someone smarter than I figure this out (or maybe someone with a wiring schematic) I'm stalled till I get this figured out. mark... |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.