I installed the Van-Again fuel line kit ($53) over the weekend--excellent quality clamps and fuel line. There was enough hose to replace everything from the plastic feed line (above the starter) to the plastic return line (just forward of the engine compartment). Ken's line measurements that came with the instructions were right on. I would recommend fitting the three lines at the tee (where the test port is) out of the vehicle as the clearance is tight if you do it in place. It is a good feeling to have replaced all my pressurized fuel lines. Make sure you replace the injector seals ($4) while you are in there. Jay '85 Westy |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.