Date: Thu, 26 Apr 2001 14:52:43 MDT
Reply-To: Joe Fortino <biker.pride@usa.net>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Joe Fortino <biker.pride@usa.net>
Subject: Re: [Re: Idle Stabilizer Valve]
Content-Type: text/plain; charset=US-ASCII
Guys,
will this also cause longer warmup times if the unit is out?
my van takes like friggin 5 mins to warmup, and will stall a bit
if not warm.
Joe
Karl Wolz <wolzphoto@worldnet.att.net> wrote:
Y'know David, it's not often that I get to correct you, so if I get the
opportunity, I'm gonna damn well jump on it.
The "auxiliary air regulator" does indeed sit on top of the 1.9 and just
below and to the left of the AFM. It's kind of an anvil shaped doohickey
that allows extra air into the engine on cold starts (the logic of which
escapes me as I thought you would want a richer mixture for a cold start).
It has an electrical contact on one end (connected to a heating element so
it won't stay on too long) and an air hose coming out each end, one of which
goes to the rubber intake boot.
This part is NOT this gentleman's problem, but it DOES exist.
The hunting is probably from a too lean mixture at idle, but you know that.
Most likely bypassing the idle stabilizer won't do much for him.
Karl Wolz
----- Original Message -----
From: "David Beierl" <dbeierl@attglobal.net>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Wednesday, April 25, 2001 10:27 PM
Subject: Re: Idle Stabilizer Valve
> At 12:36 AM 4/26/2001, John Clavin wrote:
> >The idle speed on my '85 GL is "hunting" (revving up a few hundred rpm
> >every second or so). I am working through a checklist of suggested fixes
> >from the archives on this and have a problem identifying the idle
> >stabilizer valve. Is this the part which Bentley refers to as an
"auxiliary
> >air regulator" sitting on top of the engine almost underneath the air
flow
> >meter?
>
> You haven't got one, that's the 2.1l setup. You have an electronic idle
> stabilizer mounted on the left firewall near the coil. Disconnect it and
> plug the wires into each other. If the problem goes away then you need to
> fix or replace that.
>
> If not, or maybe even first, make sure that your throttle is fully
closing,
> and that the closed-throttle switch is set and operating correctly. If
> that switch sticks closed (or if idle is set too high) the motor will shut
> off every time it gets to 1500 rpm and restart as it gets down to about
> 1000 rpm.
>
> david
>
>
> >John Clavin
> >jc@austin.rr.com
>
> David Beierl - Providence, RI
> http://pws.prserv.net/synergy/Vanagon/
> '84 Westy "Dutiful Passage"
> '85 GL "Poor Relation"
>
____________________________________________________________________
Get free email and a permanent address at http://www.netaddress.com/?N=1