Date:         Tue, 24 Apr 2001 14:14:51 -0400
Reply-To:     Jay L Snyder <Jay.L.Snyder@usa.dupont.com>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jay L Snyder <Jay.L.Snyder@usa.dupont.com>
Subject:      '85 Crank Pulley Diameter?
Content-type: text/plain; charset=us-ascii

Anyone have a pulley off, or a motor sitting around that could accurately
measure the crank pulley diameter ('85 Digijet type)?  I need the diameter
were the current timing mark is now.  I am looking to mark mine at 5
degrees BTDC and out at ~40 BTDC  to check my centrifugal advance.   I am
sure someone on the list has already done this.....

                                                             Jay

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.