Date:         Wed, 2 May 2001 10:33:53 MDT
Reply-To:     Joe Fortino <biker.pride@usa.net>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Joe Fortino <biker.pride@usa.net>
Subject:      Re: [Re: part number]
Comments: To: Keith Adams <keith_adams@transcanada.com>
Content-Type: text/plain; charset=US-ASCII

ya beat me to it.. I just replaced mine, lucky i had the wife as
a co-helper. I must have said about 20 bad words tring to replace
such an eazy thing.. it was like a puzzel to me. LOL

 * make sure you grease parts well *

Joe



Keith Adams <keith_adams@transcanada.com> wrote:
Hola back,

I've got the ETKA print out sitting here.  As far as the parts go, you'll

need:
823 711 643 A - ball socket for gearshift lever
823 711 199 - pressure spring
251 711 645 - hemisphere
823 711 255 - bearing for socket (need 2)
171 711 279 - rubber mounting
171 711 227 A - spacer ring

All the above pieces you can pre-assemble and drop in as a unit.  That's
what I
did.

171 711 166 - bushing (2 required) - these are the bushings where the pin

goes
through the shift rod.  You have to get at these by dropping the spare
tire and
dropping the bottom off the shift box.  They make a big difference too and
are
cheap.

Hope that helps,
Keith Adams
Calgary, Alberta, Canada
86 Westy "Roxy" / 87 Syncro porject "Hugh"

Hector Moreno wrote:

>  Hola amigos,
> I am down here in cancun and I need to replace the bushings in the
> shifter,
> does anyone know the parts numbers of such pieces so that I can look for
> them before I take them apart?
> Gracias!!!!
> Hector
> (the Only '86 crew cab diesel in southern mexico)


____________________________________________________________________
Get free email and a permanent address at http://www.netaddress.com/?N=1