Spent a couple of hours looking in the archives, just couldn't find any good tips on this. Engine is on a bench, and I have only a 150ft-lb max capacity torque wrench. Need advice on how to get the pulley (3 groove) properly torqued onto the crankshaft of a new Boston Bob engine that is itching to get put into my van. I can rig up rent/buy whatever I need. Maybe somebody will loan/rent me the VW special tool? Thanks, Steve '86 Westy
[text/html]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.