Date:         Fri, 11 May 2001 21:59:56 -0700
Reply-To:     steve@syncro.org
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Steve Schwenk <steve@syncro.org>
Subject:      Re: [Syncro] Fender Flare Attachemnt
Comments: To: Syncro5@aol.com
Comments: cc: sxs@concentric.net, Syncro@yahoogroups.com
Content-Type: text/plain; charset=us-ascii

Thanks, Ken.  I am just taking a break from mounting
the fronts.  I used stainless steel rivets.  One of my
fron flares came pre-drilled, the other did not.  Once
i figured out that the fiberglass just follows the edge
of the steel, it was easy and is sturdy.

Coming to Hollister, Ken?  It's right down the road.
steve

Syncro5@aol.com wrote:
>
> In a message dated 5/11/01 11:09:03 AM, sxs@concentric.net writes:
>
> >Can someone tell me how the front fender flares are
> >attached to the 16" syncros
>
> Hi Steve and All,
>
> I have the 16'' fender flares on my syncro.  The front are two piece, the big
> part mount on to the door as you said.  Since mine came with no hardware, I
> used stainless steel screws to fasten them to the doors. There were no holes
> in this part of the flares, so I drilled my own.
>
> Good Luck.
> Ken Herman
> 86 Syncro Westy