In order to get the rear seat/bed to be flat, first pull the release handle in the back of the seatback to unlock it. Then tilt the seatback slightly forward to keep it from re-engaging the latch. Next, pull forward and up on the seat bench. This also pulls the seatback into the horizontal position. (This sounds much more difficult than it really is.) I suspect you were simply pushing the seatback towards the horizontal position, which you have found will not work properly. Also, if you have head rests on the rear seat, they must be removed prior to making your bed. They either have a quick disconnect lever (in later years), or else you need to remove a circlip (hidden just under the fabric). The headrests can be quickly reinstalled when desired. Welcome to the wonderful world of Vanagons! Budd Premack 86 Syncro, 73 Super Minneapolis, MN (Land of Sky-Blue Waters) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.