i took down my drive (propeller) shaft just after buying our syncro in march because the tires were very bad and i didn't want to take a chance on ruining/damaging any further then vc. as well, it needed to be rebuilt. well, the rebuild is done, and i put our new wheels/tires on tuesday. so, i thought i would slip the driveshaft back on and 4WD to hollister tomorrow. now that i know how it comes apart, i can get it back together easily. not so fast. i loosely bolted the shaft to the transmission flange, and was going to loosely bolt it to the front diff flange prior to tightening down the bolts at the transmission end. when i lifted up and mated the two flanges at the front diff, the bolt holes were not lined up. i rotated the front diff flange one way, and the driveshaft the other, and they would not match. then reversed that rotation, still no match. after talking with another listmember (it didn't work, ben), i thought to rotate the transmission by rolling a bit in gear with the driveshaft resting on a box. silly me! of course, when the front wheels turned, it turned the front differential shaft as well. so i got nowhere with that. now i think i need to (a) get a 4x4 and a good, high-lift 2-ton floor jack and lift the rear wheels off the ground, put it in granny gear, and let the wheels turn with the clutch out just a bit so the rear flange turns but the front will not, or (b) go at some point tomorrow to a shop and ask if i can use their brake stand so the rears will roll while the fronts stay still, again to turn the rear flange. (a) is less safe (even with jackstands and chocks) than (b), but perhaps i won't be able to get to a shop this weekend. so maybe (a) on sunday. i dunno. btw, the driveshaft geometry is such that everything is 90 degrees to the other, and putting it back together improperly doesn't seem like it can be the culprit. any suggestions? i am *way* open to them. my wife, son, and i will be hitting hollister tomorrow morning for a couple of hours, and will discuss it with the folks there...but anyone here who can chime in about my assumptions or methods or conclusions is more than welcome to! thanks. bill |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.