Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2001, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 21 May 2001 11:38:10 -0700
Reply-To:     Jere & Beth Hawn <jbrschawn@earthlink.net>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jere & Beth Hawn <jbrschawn@earthlink.net>
Subject:      Re: inner bearings?
Comments: To: Jeff and Deb <jeffndeb@gci.net>
In-Reply-To:  <000a01c0e1c8$05e9efa0$0b8eed18@jeff>
Content-Type: text/plain; charset="Windows-1252"

Jeff,

I had a similar problem about a month ago, I got the inner bearing to replace it and found during disassembly that the axle nut wasn't on tight enough. I got out my special $19.95 46mm Axle tightening digi-wrench, breaker bar, and a 3 lbs. Sledge and whammo it was done.

Check your axle net.

Jere 90 GL 88 GL

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Jeff and Deb Sent: Monday, May 21, 2001 12:31 AM To: vanagon@GERRY.VANAGON.COM Subject: inner bearings?

Hi All, A few previous posts suggest a possible diagnosis for some rumbling noises that I have been hearing in the back of my 86 Vanagon. It seems to be making a louder than normal low roaring sound on cornering at speeds above 45 MPH. I have had brake work done, and had my outer bearings inspected, with no negative reports. Also, it seems to get louder with speed on the highway. The exhaust system, that I thought might be leaking or contacting some object, is completely tight, and without leaks. I tried the archives on "inner bearings" but timed out before getting my search to cover more than a year.

Any suggestions on a positive way to troubleshoot it without tearing everything down? Also, if it is an inner rear bearing, I assume that it is necessary to replace all four bearings, or at least pack the outer ones if they are not worn? Any suggestions for the correct type and manufacturer for rear bearings? Thanks, Jeff Hartman Juneau, AK 1886 Vanagon


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.