Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2001, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Tue, 22 May 2001 23:15:43 -0800
Reply-To:   Mark Keller <kelphoto@islandnet.com>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Mark Keller <kelphoto@islandnet.com>
Subject:   Vaccum Source For Fuel Pressure Regulator.
Comments:   To: Mike Vanderzanden <Brewhogger@aol.com>
Content-Type:   text/plain; charset=us-ascii

Steve,

The vacuum port for the fuel pressure regulator on my 91 is just below the power brake booster on the engine's driver side of the intake manifold.

I believe that is the only true vacuum port available. I inserted a tee connector to the hose for the vacuum gauge.

My engine reads 13" now, it has run as low as 10.5". I'd say 11- 13 is about it for a boxer at idle.

Sincerely,

Mark Keller 91 Carat Cowichan Bay, BC


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.