Might be able to use T1 bug to T4 conversion bearings main bearing, small bearing is similar to T4 (was the same except for an additional oil feed hole on opposite side) or same as a T1 bearing. An article in Hot VWs mag talked about crank dimensions and the conversion bearing might work. Also you might be able to utilize the Gene Berg Enterprises T4 to T1 split third bearing to eliminate the need to remove the crank gears during a rebuild. From the mag it might work. The only concern would be tolerances for air-cooled are slightly greater than the water-cooled. Get the .1 under bearings and have the crank ground to the correct tolerance. This could be done if the shortage continues. The bearings are the same construction. Robert
[text/html]
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.