My poor diesel friend has an oil leak. Here are some of the details. The oil leaks from areas where there are seals, main seals, head gasket, etc. There does not seem to be leaks at the filler tube, oil pressure sensor, or valve cover gasket. I replaced the head bolts. The leak was better then went back to the same rate. The rate of leakage increases with engine speed. At an indicated 50mph (62 actual, don ’t you just love VDO) a small amount of leakage, and a few spots on the rear window. At an indicated 55mph the rear of the van gets covered in oil spots. Then I replaced the engine with a long block from GEX. I have the same oil pump, fuel system, valve cover, oil pan, exhaust system, hoses, vacuum pump. The oil leak still occurs, maybe at a lower rate but the rear of my van is covered in oil. Any suggestions would be greatly appreciated. I have followed the advice of Stuart Hutton and tracked down the leaks. I am just wondering why I have them in the same place with a rebuilt motor.
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.