> Also, if you ever disassemble the driveshaft, be sure to put it back > together with the U-Joints in correct phase. O.K. Tom, I'll bite, how do you determine the correct phase of a U-joint? > I have never seen a Syncro dirveshaft. Can you describe the mechanical > configuration? The main drive shaft on a syncro (not the axles) is similar in length to a conventional shaft on a domestic car. One end has a welded on yoke with a conventional U-joint and a flange that bolts to the front differential. The tranny end is a different beast. Starting at the tranny, there is the same flange as on the front end of the shaft. Into that flange is the U-joint and another flange that bolts to a concentric rubber donut. The donut (re-inforced) then bolts to four bosses that are part of the welded end of the shaft. My assumption was that the donut carried all of the force similar to what you would see on a steering shaft connection. That was partially correct, as the torque is carried by it, but what you don't see is that there is an extended shaft (~6") that goes into the welded end of the shaft that ensures alignment of the flange assembly and the shaft. The "flange shaft" is necked in the middle and had two support surfaces, one at the base and one at the end. They ride in bronze bearings and prevent deflection of the yoke due to the flex at the donut. The end of the shaft is where I saw the wear marks that I believe are the culprit. Sorry to all of the non-syncro owners if the description is boring to you. I have just seen too many requests as to why they have a vibration around 50 mph that they couldn't explain. Hope this helps. Mark Rokus '87 GL Syncro Westy '87 GL Syncro '86 Syncro (hanger Queen) '81 Westy Aircooled '82 Rabbit Diesel |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.