gang, I need two parts to finish my '86 into a '90 engine install. can anyone help? 1 - the elbow shaped, 2" diameter rubber hose that runs from (below) the thermostat housing to the main rigid coolant line. 2 - the rubber, 1/2" (?) diameter hose that runs from the back (toward the front of the bus) of the thermostat housing up to the plastic line above it that runs under the engine cover. this hose is larger at the thermostat end than it is at the plastic nipple connection end, and it's about 6-8" long. any help you can lend would be greatly appreciated. i have some parts for sale as well; complete exhaust - from a '90 (needs new cat. converter) heat sheild - for over exhaust air box - '86 or '90 (which begs a good question: if you put an '86 engine in a '90 bus, which airbox will you use, the '86 or the '90?) other stuff i can't remember - email me thanks again t |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.