Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2001, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 22 Jun 2001 15:09:50 -0700
Reply-To:     steve@SYNCRO.ORG
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Steve Schwenk <steve@SYNCRO.ORG>
Subject:      Re: What's Inside Vanagon Nose?
Comments: To: Karl Wolz <wolzphoto@worldnet.att.net>
Content-Type: text/plain; charset=us-ascii

No, it's a small dent. Looks like someone hit it with their hand. I'm off to meet the dent remover guy. They took a dent out of my sliding door several years ago for $125 in about 15 min. and it looks perfect.

I'll let you know what he says. I am meeting him at a car dealer so he can show me where to drill an access hole, which is nothing. He is a mobile unit.

Karl Wolz wrote: > > Steve, > > If it's a big, broad dent, you might try pulling it out with a suction > device, such as that used by window installers. I'd certainly try that > before drilling any holes. > > Karl Wolz > > ----- Original Message ----- > From: "Steve Schwenk" <steve@SYNCRO.ORG> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Friday, June 22, 2001 1:39 PM > Subject: What's Inside Vanagon Nose? > > > To my horror, I discovered a dent in the fron of my > > vanagon...right in the nose...that wide, flat piece of > > metal just below the windshield and above the radiator. > > > > The good news is that it sould pop right out using the > > paintless dent removal service (air bag from behind). > > The bad news is that there is no external access to the > > space because there is a piece of steel attached just > > below it to form a double wall effect. I would have to > > remove the dash to get to it. > > > > I would like to just drill a hole (1")in the lower > > portion of the body piece (like this > ) so that the > > dent guy can then gain access to the rear of the dented > > portion of the sheetmetal. I can seal the hole with a > > plug like VW does in other areas. > > > > My concern: what is inside the nose? Are there wires > > or hoses or anything else i might bugger up by drilling > > into the "bottom" portion of the nose behind the grill > > and above the radiator? > > > > Thanks for any info. > > steve > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.