Hi Daryl, Thanx for the feedback. Do you know which signals or outputs cause the ECS lamp to light? If we knew this at least that lamp being lit or not would tell whether the "monitored" group contained the problem.. When I get a minute(ha,ha,ha,!)I'm going to rig an LED using my 25 pin BOB and set some faults in my '91 MV. If this function can give me a blinking pass-fail(albeit broad)on a group of signals, I still may wire an LED in the inst cluster. While we're talking, why does the DCM check the main relay control circuit power via pin 23? If the main relay control power is missing - the DCM is dead!!!
Regards, John |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.