Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2001, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 27 Jun 2001 15:04:48 -0700
Reply-To:     Pancho de la Luna <pancho@SPEAKEASY.ORG>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Pancho de la Luna <pancho@SPEAKEASY.ORG>
Subject:      Re: Monster TO-DO List
Comments: To: Todd Greenwood <toddg@MICROSOFT.COM>
In-Reply-To:  <86E2EAA8E44E3C4F8758D76CC540794003E93F9B@red-msg-01.redmond.corp.microsoft.com>
Content-Type: multipart/alternative;

MessageTodd-

Here in Seattle I generally run 30hd since my engine is so old. (170k- just flipped 170k on my way in to the office this morning)

When driving down to the warmer climes of California, Nevada for Burning Man, and Texas, I change the oil before I go and put in 40 just to help increase the oil pressure and make sure that there's enough viscosity to keep long travel wear down to a minimal. after about 300miles of driving around 60-65 mph- your engine will loosen up a bit and it'll drive solidly. that's usually my favorite part of the trip. (these trips usually take place in the summer. If you're traveling in the winter- I'd say that 30hd would be fine all the way.)

thoughts on the external oil cooler- I had one on a '72 camper van. it basically allowed for more oil to run through the engine, but generally made for a HUGE mess because the thing wasn't designed very well. lots of little leaks and new holes to punch through the metal, etc. if you feel that it is necessary, then you need to get a bigger oil pump (you'll need it to increase oil pressure through the new lines that run to the cooler outside of the vehicle) then I'd say do it. but- really- it's not needed.

Also- from past experience- driving south from here in Seattle, there are 3 mountain passes in Oregon; the last one being Grants Pass, OR. make sure that you have some grease injected in to the CV boots (all four of them) before you go to keep the CV joints from going out on you in the passes. Westies weigh quite a bit and pushing them over mountain passes without enough lube can cause some pretty big problems.

Regarding the skylight- I'd take the thing off, clean it really well and put fresh clean caulk down so that the seal is clean and fresh. make sure that you get all the old caulking off first though- it can hide dirt and cause pitting in the paint and rust eventually (we are in a rainy climate). really all you have to worry about up here is the moss that grows on the older cars. Don't park under trees very often, and you'll not have a problem with that.

Tach gauge and oil temp gauges are always good to have. If you can't throw down for all of them at the same time (meaning 1 tach, 1 oil pressure, 1 oil temp) I'd suggest the oil pressure gauge over all of them. lose pressure when you're on a mountain pass and you might find that you've blown a gasket..... it won't matter how fast your engine is spinning at that point nor will the temperature of the oil since it's gonna be on the road very shortly thereafter. ;)

Headlights- as long as the ones you have work- way replace them? if you insist on doing this- go for some halogen replacements- it's always nice to melt the eye lids off the folks driving in front of you since the stand of our Vanagons are a bit higher than the average Ford Taurus rear window.

Glass on the sliding glass door- Since Bry's is out of Biz for the time being, you'll have to call Campbell-nelson. they'll have your part but at a much higher price (unfortunately).

Any one else?

Myles '86 GL -----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf Of Todd Greenwood Sent: Wednesday, June 27, 2001 12:52 AM To: vanagon@GERRY.VANAGON.COM Subject: Monster TO-DO List

Van list -

I'm in the middle of remodeling an 80 westy, and I have a ton of questions:

I just finished rebuilding the engine (I pulled it, cleaned & repainted the steel, and had it professionally put back together). The first road trip isolated the alternator as a point of failure (on the freeway @ 2am). Now I know what the battery and egr lights mean.

I'm prepping for a long term road trip...I hope to surf Baja someday. However, I have a laundry list of repairs first. Any thoughts on this extensive list would be great.

Van TO-DO List: 1. Add Temp Gauge (I'd like to get sensors on each cylinder...overkill? At the very least, I'd like a temp gauge on the dash) 2. Add Tach Gauge (I notice there's been some discussion on this lately...I'll look thru the mail) 3. Clean mildew off inside pop-top...cleaner recommendations? 4. Clean outside mildew off outside of pop-top...The question is how to finish it so it looks like new? I just cleaned w/ tsp and Clorox. 100% better...but not 'new' looking yet...should I use rubbing compound and then wax? 5. Replace Headlights (brand recommendations?) 6. Extend gearshift lever higher...it's so low I have to bend down to reach it. I used to ride an old 77 Westy, and the PO had installed an anchor bolt to the stick arm. Does anyone make an extension? 7. Replace sink pump (any brand recommendations?) 9. Add an oil level and pressure meter...I'd like always know about this precious fluid... 10. Spare tire (---found this in Bentley---cool, need to see if I have one :o)) 11. Paint job (where can I get something cheap in the Seattle metro area? Any places to avoid?) 12. Replace missing sliding door window (glass is gone...is this a junkyard item...or something that can be fixed?) 13. External oil cooler?...should I get one? 14. Gas grade?...my mechanic recommends premium for an air cooled. Is this necessary? 15. Recommended oil, after rebuild, then later...what grade should I run for how long after a rebuild? My mechanic recommends either sae30 or 20-50. 16. Fix skylight...some DPO used sheet metal screws to put in a non-stock skylight. It's in, but it leaks...the caulking or whatever they used to seal it is cracking...what should I do? Just add more caulk, or pop for a new skylight? 17. Where are all the grease fittings? Didn't see a diagram in the Bentley ...and the front end squeaks a bit. 18. Fuel system...when I fill the tank up, the filler tube leaks a bit. Is this normal? Or do I need to start looking at the grommets and such? My plan is to drop the tank, fix the sending unit on the tank, and replace all the rubber/gaskets/fuel filter/fuel pump...anyone done this?

Thanks in advance for any answers to my newbie questions! -Todd '80 Westy


[text/html]


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.