Date:         Sat, 7 Jul 2001 10:58:34 -0700
Reply-To:     Michael Snow <mwsnow@HOME.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Michael Snow <mwsnow@HOME.COM>
Subject:      Re: Help with 1.9l Diesel Head
Comments: To: KENWILFY@AOL.COM
In-Reply-To:  <ab.be576bc.2878930e@aol.com>
Content-Type: text/plain; charset="US-ASCII"

Does your new head gasket have tightening instructions with it?  My FLAPS
carries Elring head gaskets and they come with an instruction sheet.  I am
more inclined to use the head gasket manufacturer's instructions than the
Bentley.  Sorry I have no AAZ manual to look at.

Mike Snow


-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM]On Behalf Of
KENWILFY@AOL.COM
Sent: Saturday, July 07, 2001 9:30 AM
To: vanagon@GERRY.VANAGON.COM
Subject: Help with 1.9l Diesel Head


I need the torque spec for a 1.9l Diesel engine that we are putting the head
back on.  It is a naturally aspirated, but I think the torque spec is the
same as the TDI.  I believe it is engine code AAZ.  The head bolts are the
torque-to-yield type.  I need to know the torque spec and also how much of a
turn to give it after it is torqued (quarter turn, half turn, etc.).  Any
help would be appreciated.  I have the manuals for the 1.6l, but not the
1.9l.

Thanks in advance for any help you can give,
Ken Wilford
Van-Again
John 3:16
http://www.vanagain.com
Office: (856)-765-1583
Fax: (856)-327-2242