Date:         Wed, 11 Jul 2001 09:38:17 -0400
Reply-To:     Kitzmann <kitzmann@EXIS.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Kitzmann <kitzmann@EXIS.NET>
Subject:      Re: I-4 again
In-Reply-To:  <200107110343.f6B3hLI31422@marlin.exis.net>
Content-Type: text/plain; charset="us-ascii"

<1) use the A2 intake manifold or one from an 82' Quantom(4cyl)?
I used the A2 manifold, but it interferes with the wall on the drivers
side, I don't know anything about the Quantom manifold.

<2) what did you do when the dipstick hole is/was(since I will using the
one for the <diesel oilpan instead)?
I bent the tube slightly to get it out of the way and put a small elastic
cap over the top.  The cap that I found that worked well came from home
depot, found it in the hardware aisle.

Dave K.
1.8 Cis-e conversion

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.