Just did this. Pry, gently, around the edges of the panel. Where it's tightly held is where there is a snap. Get a flat blade inside the panel there and pry out gently until the snap pops out. I had to do two on the top, those on the front side and two on the bottom to get at the screw. Your mileage may vary. To reinstall put the farthest back snap in the hole where it belongs and push in right over the top of it. It should just snap right in. Then do the others moving forward, they should line up easily. Good luck. Mike ----- Original Message ----- From: PSavage <psavage@SABER.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Monday, July 16, 2001 6:44 PM Subject: Removing Door Panel
> Thanks, All, > for advice on the "loose screw fix" for my sliding door handle. > Now, how do I "pop" the door panel off--I don't want to damage > anything. And once it's "popped" off, is it difficult to "pop" back on? > ??? > Thanks, > Phaedra > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.