At 02:04 PM 7/21/2001, Jeff Howard wrote: >Fridge is running ok. I looked at the >little LED panel below the stove (Delta >Six part). There's no voltage across >the LED leads and there's only a supply >voltage to one of the two IC's on the >little circuit board. ANyone know where >I might find a schematic? Look on my website -- there are two drawings for water-level and flame detector circuits. Flame detector is one of the amplifiers in the right-hand chip, pin numbers on the schematic. > It appears >that the water levels in the water tank >may be using the same IC. Water uses the first three amps in the left-hand chip. The fourth is spare. Pin numbers on schematic. > I don't have water >in the tank but took a look and saw a >black module screwed to the outside wall >of the water container compartment. The >water level sensors have wires leading into >this module. ANyone know what that module >does? Provides a variable (high) resistance to ground depending on what the water level is. The green wire from the LED panel is biased high with one megohm, gets pulled down to variouslevels depending. Ask me any questions after you take a look at the schematic. david |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.