Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2001, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 29 Jul 2001 11:13:57 -0700
Reply-To:     pensioner <al_knoll@PACBELL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         pensioner <al_knoll@PACBELL.NET>
Subject:      Re: Tach Conversion
Content-type: text/plain; charset=iso-8859-1


Hi Chris,


If the objective is to put a tach into your 89 cluster it's MUCH simpler
than putting the circuitry into the 84.  You'll need a FCA Flexible Circuit
Assembly, that's the blue plastic connector sheet that covers the back of
the cluster which has the Tach connections.  The wiring harness already has
the tach wire included.  The harness plugs into the cluster.


Then just remove the clock system and add the tach in it's place.
Mechanical exchange.  Far simpler in my opinion and it retains all the
sensor stuff you seem to want.


Cheers,


pensioner
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.