Just check some of your local steel fabricators - they should be able to weld you up something with steel stock on hand. Take them the bus and the hitch ball you want to use. -OR- I have a similar hitch on my CR-V. Different receiver size I think - smaller than most other receivers. (the hole that the hitch would slide into). You could check with NAPA. They can order many different sizes. Take care. At 09:09 PM 8/10/01 -0400, you wrote: >The '84 came with a trailer hitch that takes a 1-1/8" square bracket. In >other words, there's a square hole into which should fit a bracket. On to >the bracket I would fasten the hitch ball. Sure seems small to me. >Everything I see is more like 1-1/4" - 2" +. What size is your hitch? Any >idea where I might find the part I'm looking for? > >Bradley Flubacher >State College, PA >'82 VW diesel westy >'84 GL wasserboxer Ciao! Chris Mills <Busbodger> Cookeville, Tennessee ICQ#5944649 scm9985@tntech.edu '78 VW Westfalia (Corvair drivetrain waiting transplant) '65 Beetle - Type IV powered '99 CR-V station wagon '81 CB900 Custom moto-chickle FOR SALE: '72 Hodaka Wombat (make offer) Early model Corvair engine - needs bell housing, otherwise complete (make offer) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.